All Shoals Harpoon components are made locally here in New England using the finest raw materials.
We supply 3/8 inch stainless steel button screws which secure the head and rear section pieces of the harpoon.
To assemble: Measure 1 inch from the end of the pipe on both ends — mark where the screws will fit the pipe and drill a starter hole —3 button socket screws secure each end piece of the harpoon in place. Simple!
The kit consists of the following parts
1 – Harpoon brass head approx. 1lb 6oz ( weighted to throw at fish under water) drilled and tapped in 3 places —head is machined to fit inside schedule 40 aluminum conduit harpoon shaft
1 – Harpoon end cap and Carbineer –with unique machined piece that holds carbineer included (to clip on main line) —machined to fit inside schedule 40 aluminum conduit harpoon shaft
1 – Stainless Pike 3/8 inch –approx. 18 inches long —-screws into end of harpoon head
6 — Button socket head stainless steel screws —- secures end cap and harpoon head
1 – Set of directions to make your own harpoon
Suggested Price is $89.00
Note: Picture shows the Schedule 40 Aluminum conduit in the Pictures and a rigged dart —it is NOT included and is for illustration purposes only.
Fully Rigged Darts and Darts are available.